The LPC1114FBD48 is an ARM Cortex-M0 microcontroller and it can operate up to 50 MHz. The peripheral complement of the LPC1114FBD48 includes 32 kB of flash memory, 8 kB of data memory, one Fast-mode Plus I²C-bus interface, one RS-485/EIA-485 UART, two SPI interfaces with SSP features, four general purpose counter/timers, a 10-bit ADC, and 42 general purpose I/O pins. In addition, the LPC1114FBD48 features unique on-chip API-driven power profiles which provide users with ready-to-use power management templates. Optimized for CPU performance, CPU efficiency and lowest active current, the power profiles enable maximum operating frequency through the entire voltage range from 1.8 V to 3.6 V without compromising speed or functionality.
MoreLess
## Features
* ARM Cortex-M0 processor, running at frequencies of up to 50 MHz
* ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC)
* Serial Wire Debug
* System tick timer
* 32 kB on-chip flash programming memory
* 8 kB SRAM
* In-System Programming (ISP) and In-Application Programming (IAP)
* 42 General Purpose I/O (GPIO) pins with configurable pull-up/-down resistors
* High-current output driver (20 mA) on one pin
* Programmable WatchDog Timer (WDT)
* 10-bit ADC with input multiplexing among 8 pins
* UART with fractional baud rate generation
* Two SPI controllers with SSP features and FIFO and multi-protocol capabilities
* I²C-bus interface supporting full I²C-bus specification and Fast-mode Plus
* Integrated PMU (Power Management Unit) to minimize power consumption
* Power profiles residing in boot ROM (LPC1100Land LPC1100XL series only)
