* Core: 100 MHz/131 DMIPS MIPS32® M4K® * MIPS16e® mode for up to 40% smaller code size * Code-efficient (C and Assembly) architecture * Single-cycle (MAC) 32x16 and two-cycle 32x32 multiply * Clock Management * 0.9% internal oscillator * Programmable PLLs and oscillator clock sources * Fail-Safe Clock Monitor (FSCM) * Independent Watchdog Timer * Fast wake-up and start-up * Power Management * Low-power management modes (Sleep and Idle) * Integrated Power-on Reset, Brown-out Reset, and High * Voltage Detect * 0.5 mA/MHz dynamic current (typical) * 50μA IPD current (typical) * Audio/Graphics/Touch HMI Features * External graphics interface with up to 34 PMP pins * Audio data communication: I2S, LJ, RJ, USB * Audio data control interface: SPI and I2C™ * Audio data master clock: * Generation of fractional clock frequencies * Can be synchronized with USB clock * Can be tuned in run-time * Charge Time Measurement Unit (CTMU): * Supports mTouch™ capacitive touch sensing * Provides high-resolution time measurement (1 ns) Advanced Analog Features * ADC Module: * 10-bit 1 Msps rate with one Sample and Hold (S&H) * Up to 28 analog inputs * Can operate during Sleep mode * Flexible and independent ADC trigger sources * On-chip temperature measurement capability * Comparators: * Two dual-input Comparator modules * Programmable references with 32 voltage points Timers/Output Compare/Input Capture * Five General Purpose Timers: * Five 16-bit and up to two 32-bit Timers/Counters * Five Output Compare (OC) modules * Five Input Capture (IC) modules * Peripheral Pin Select (PPS) to allow function remap * Real-Time Clock and Calendar (RTCC) module * Communication Interfaces * USB 2.0-compliant Full-speed OTG controller * Up to five UART modules (20 Mbps): * LIN 1.2 protocols and IrDA®support * Two 4-wire SPI modules (25 Mbps) * Two I2C modules (up to 1 Mbaud) with SMBus support * PPS to allow function remap * Parallel Master Port (PMP) * Direct Memory Access (DMA) * Four channels of hardware DMA with automatic data size detection * 32-bit Programmable Cyclic Redundancy Check (CRC) * Two additional channels dedicated to USB * Input/Output * 15 mA or 12 mA source/sink for standard VOH/VOL and up to 22 mA for non-standard VOH1 * 5V-tolerant pins * Selectable open drain, pull-ups, and pull-downs * External interrupts on all I/O pins Qualification and Class B Support * AEC-Q100 REVG (Grade 2 -40°C to +105°C) planned * Class B Safety Library, IEC 60730 * Debugger Development Support * In-circuit and in-application programming * 4-wire MIPS® * Enhanced JTAG interface * Unlimited program and six complex data breakpoints * IEEE 1149.2-compatible (JTAG) boundary scan
