The TMS320C32 is the newest member of the TMS320C3x generation of digital signal processors (DSPs) from Texas Instruments. The TMS320C32 is an enhanced 32-bit floating-point processor manufactured in 0.7-um triple-level-metal CMOS technology. The enhancements to the TMS320C3x architecture include a variable-width external-memory interface, faster instruction cycle time, power-down modes, two-channel DMA coprocessor with configurable priorities, flexible boot loader, relocatable interrupt-vector table, and edge- or level-triggered interrupts.
High-Performance Floating-Point DSP
TMS320C32-60 (5 V)
33-ns Instruction Cycle Time
330 Million Operations Per Second (MOPS), 60 Million Floating-Point Operations Per Second (MFLOPS), 30 Million Instructions Per Second (MIPS)
TMS320C32-50 (5 V)
40-ns Instruction Cycle Time
275 MOPS, 50 MFLOPS, 25 MIPS
TMS320C32-40 (5 V)
50-ns Instruction Cycle Time
220 MOPS, 40 MFLOPS, 20 MIPS
32-Bit High-Performance CPU
16-/32-Bit Integer and 32-/40-Bit Floating-Point Operations
32-Bit Instruction Word, 24-Bit Addresses
Two 256 × 32-Bit Single-Cycle, Dual-Access On-Chip RAM Blocks
Flexible Boot-Program Loader
On-Chip Memory-Mapped Peripherals:
One Serial Port
Two 32-Bit Timers
Two-Channel Direct Memory Access (DMA) Coprocessor With Configurable Priorities
Enhanced External Memory Interface That Supports 8-/16-/32-Bit-Wide External RAM for Data Access and Program Execution From 16-/32-Bit-Wide External RAM
TMS320C30 and TMS320C31 Object Code Compatible
Fabricated using 0.7 um Enhanced Performance Implanted CMOS (EPICTM) Technology by Texas Instruments (TITM)
144-Pin Plastic Quad Flat Package
(PCM Suffix) 5 V
Eight Extended-Precision Registers
Two Address Generators With Eight Auxiliary Registers and Two Auxiliary Register Arithmetic Units (ARAUs)
Two Low-Power Modes
Two- and Three-Operand Instructions
Parallel Arithmetic Logic Unit (ALU) and Multiplier Execution in a Single Cycle
Block-Repeat Capability
Zero-Overhead Loops With Single-Cycle Branches
Conditional Calls and Returns
Interlocked Instructions for Multiprocessing Support
One External Pin, PRGW, That Configures the External-Program-Memory Width to
16 or 32 Bits
Two Sets of Memory Strobes (STRB0\ and STRB1\\) and One I/O Strobe (IOSTRB\\) Allow Zero-Glue Logic Interface to Two Banks of Memory and One Bank of External Peripherals
Separate Bus-Control Registers for Each Strobe-Control Wait-State Generation, External Memory Width, and Data Type Size
STRB0\ and STRB1\ Memory Strobes Handle 8-, 16-, or 32-Bit External Data Accesses (Reads and Writes)
Multiprocessor Support Through the HOLD\ and HOLDA\ Signals Is Valid for All Strobes
EPIC and TI are trademarks of Texas Instruments Incorporated.
