The STM32F469NIH6 is a STM32 F4 series 32-bit Microcontroller based on the high-performance ARM Cortex-M4 RISC core operating at a frequency of up to 180MHz. Its Cortex-M4 core features a FPU single precision which supports all ARM single precision data-processing instructions and data types. It also implements a full set of DSP instructions and a memory protection unit (MPU) which enhances application security. The device incorporate high-speed embedded memories (up to 2048kB of Flash memory, up to 384kB of SRAM), up to 4kB of backup SRAM and an extensive range of enhanced I/Os and peripherals connected to two APB buses, two AHB buses and a 32-bit multi-AHB bus matrix. This device offer three 12-bit ADC, two DACs, a low-power RTC, twelve general-purpose 16-bit timers including two PWM timer for motor control, two general-purpose 32-bit timers, as well as standard communication interfaces - up to three I²Cs, six SPIs, two I²Ss, four USARTs and four UART.
225 DMIPS/1.25 DMIPS/MHz (Dhrystone 2.1)
Chrom-ART Accelerator™ (DMA2D)
LCD parallel interface, 8080/6800 modes
LCD TFT controller supporting up to XGA resolution
MIPI® DSI host controller supporting up to 720p 30Hz resolution
4 to 26MHz Crystal oscillator
Internal 16MHz factory-trimmed RC (1% accuracy)
32kHz Oscillator for RTC with calibration
Sleep, stop and standby modes
VBAT supply for RTC, 20 x 32-bit backup registers and optional 4kB backup SRAM
2 x Watchdogs and SysTick timer
SWD and JTAG interfaces
Cortex-M4 Trace Macrocell™
Serial audio interface
2 x CAN (2.0B Active) interface
SDIO interface
USB 2.0 full speed device/host/OTG controller with on-chip PHY
USB 2.0 high-speed/full-speed device/host/OTG controller
8 to 14-bit parallel camera interface up to 54Mbps