The STM32F439IGH6 is a STM32 F4 series 32-bit Microcontroller based on the high-performance ARM Cortex-M4 RISC core operating at a frequency of up to 180MHz. Its Cortex-M4 core features a floating point unit (FPU) single precision which supports all ARM single precision data-processing instructions and data types. It also implements a full set of DSP instructions and a memory protection unit (MPU) which enhances application security. The device incorporate high-speed embedded memories (up to 1024kB of Flash memory, up to 256kB of SRAM) and an extensive range of enhanced I/Os and peripherals connected to two APB buses, two AHB buses and a 32-bit multi-AHB bus matrix. This device offer one 12-bit ADC, two DACs, a low-power RTC, twelve general-purpose 16-bit timers including two PWM timer for motor control, two general-purpose 32-bit timers, a true RNG, as well as standard communication interfaces - up to three I²Cs, six SPIs, two I²Ss, four USARTs and four UART.
225 DMIPS/1.25 DMIPS/MHz (Dhrystone 2.1)
LCD parallel interface, 8080/6800 modes
LCD-TFT controller up to XGA resolution with dedicated Chrom-ART Accelerator™
4 to 26MHz Crystal oscillator
Internal 16MHz factory-trimmed RC (1% accuracy)
32kHz Oscillator for RTC with calibration
Internal 32kHz RC with calibration
Sleep, stop and standby modes
VBAT supply for RTC, 20 x 32-bit backup registers and optional 4kB backup SRAM
SWD and JTAG interfaces
Cortex-M4 Trace Macrocell™
Serial audio interface
2 x CAN (2.0B Active) and SDIO interface
USB 2.0 high-speed/full-speed device/host/OTG controller
10/100 Ethernet MAC with dedicated DMA - supports IEEE 1588v2 hardware, MII/RMII
