下载
Freescale Semiconductor
Data Sheet: Technical Data
Document Number: MPC5607B
Rev. 8, 04/2014
© Freescale Semiconductor, Inc., 2010-2014. All rights reserved.
MPC5607B
100 LQFP
14 mm x 14 mm
144 LQFP
20 mm x 20 mm
176 LQFP
24 mm x 24 mm
208 MAPBGA
17 mm x 17 mm
• Single issue, 32-bit CPU core complex (e200z0h)
— Compliant with the Power Architecture
®
technology embedded category
— Enhanced instruction set allowing variable
length encoding (VLE) for code size footprint
reduction. With the optional encoding of mixed
16-bit and 32-bit instructions, it is possible to
achieve significant code size footprint
reduction.
• Up to 1.5 MB on-chip code flash memory supported
with the flash memory controller
• 64 (4 × 16) KB on-chip data flash memory with ECC
• Up to 96 KB on-chip SRAM
• Memory protection unit (MPU) with 8 region
descriptors and 32-byte region granularity on certain
family members (Refer to Table 1 for details.)
• Interrupt controller (INTC) capable of handling 204
selectable-priority interrupt sources
• Frequency modulated phase-locked loop (FMPLL)
• Crossbar switch architecture for concurrent access to
peripherals, Flash, or RAM from multiple bus
masters
• 16-channel eDMA controller with multiple transfer
request sources using DMA multiplexer
• Boot assist module (BAM) supports internal Flash
programming via a serial link (CAN or SCI)
• Timer supports I/O channels providing a range of
16-bit input capture, output compare, and pulse
width modulation functions (eMIOS)
• 2 analog-to-digital converters (ADC): one 10-bit and
one 12-bit
• Cross Trigger Unit to enable synchronization of
ADC conversions with a timer event from the
eMIOS or PIT
• Up to 6 serial peripheral interface (DSPI) modules
• Up to 10 serial communication interface (LINFlex)
modules
• Up to 6 enhanced full CAN (FlexCAN) modules
with configurable buffers
• 1 inter-integrated circuit (I
2
C) interface module
• Up to 149 configurable general purpose pins
supporting input and output operations (package
dependent)
• Real-Time Counter (RTC)
— Clock source from internal 128 kHz or 16 MHz
oscillator supporting autonomous wakeup with
1 ms resolution with maximum timeout of 2
seconds
— Optional support for RTC with clock source
from external 32 kHz crystal oscillator,
supporting wakeup with 1 sec resolution and
maximum timeout of 1 hour
• Up to 8 periodic interrupt timers (PIT) with 32-bit
counter resolution
• Nexus development interface (NDI) per IEEE-ISTO
5001-2003 Class Two Plus
• Device/board boundary scan testing supported per
Joint Test Action Group (JTAG) of IEEE (IEEE
1149.1)
• On-chip voltage regulator (VREG) for regulation of
input supply for all internal levels
MPC5607B Microcontroller
Data Sheet
页面指南
