The LPC1763 is a Cortex-M3 microcontroller for embedded applications featuring a high level of integration and low power consumption at frequencies of 100 MHz. Features include 256 kB of flash memory, 64 kB of data memory, 8-channel DMA controller, 4 UARTs, 3 SSP/SPI, 3 I2C, I2S, 8-channel 12-bit ADC, 10-bit DAC, motor control PWM, Quadrature Encoder interface, 4 general purpose timers, 6-output general purpose PWM, ultra-low power Real-Time Clock with separate battery supply, and up to 70 general purpose I/O pins. The LPC1763 is pin-compatible to the 100-pin LPC2368 ARM7 MCU
MoreLess
## Features
* ARM Cortex-M3 processor, running at frequencies of up to 100 MHz
* ARM Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC)
* Up to 256 kB on-chip flash programming memory
* Up to 64 kB On-chip SRAM
* In-System Programming (ISP) and In-Application Programming (IAP)
* Eight channel General Purpose DMA controller (GPDMA)
* Four UARTs with fractional baud rate generation, internal FIFO, and DMA support
* SPI controller with synchronous, serial, full duplex communication
* Two SSP controllers with FIFO and multi-protocol capabilities
* Three enhanced I2C bus interfaces
* I2S (Inter-IC Sound) interface
* 70 General Purpose I/O (GPIO) pins with configurable pull-up/down resistors
* 12-bit/8-ch Analog/Digital Converter (ADC) with conversion rates up to 200 kHz
* 10-bit Digital/Analog Converter (DAC) with dedicated conversion timer and DMA
* Four general purpose timers/counters
* One motor control PWM with support for three-phase motor control
* Quadrature encoder interface that can monitor one external quadrature encoder
* One standard PWM/timer block with external count input
* Low power RTC with a separate power domain and dedicated oscillator
* WatchDog Timer (WDT)
* ARM Cortex-M3 system tick timer, including an external clock input option
* Repetitive interrupt timer provides programmable and repeating timed interrupts
* Each peripheral has its own clock divider for further power savings
* Standard JTAG test/debug interface for compatibility with existing tools
* Integrated PMU (Power Management Unit)
* Four reduced power modes: Sleep, Deep-sleep, Power-down, and Deep power-down
* Single 3.3 V power supply (2.4 V to 3.6 V)
* Four external interrupt inputs configurable as edge/level sensitive
* Non-maskable Interrupt (NMI) input
* Wake-up Interrupt Controller (WIC)
* Processor wake-up from Power-down mode via any interrupt
* Brownout detect with separate threshold for interrupt and forced reset
* Power-On Reset (POR)
* Crystal oscillator with an operating range of 1 MHz to 25 MHz