The HDC1050EVM is an Evaluation Module for evaluate the operation and performance of HDC1050, a humidity and temperature sensor. The board utilizes USB interface for control and data streaming and can be too plugged into a PC USB port. With the simple GUI, humidity and temperature measurements can be streaming within a matter of seconds after the EVM is attached to a PC and the GUI is started. The board hosts a MSP430F5528 MCU which acts as a bridge between the PC USB interface and the I²C interface to the HDC1050. The sensor section of the PCB may be separated from the main PCB to support prototyping in a system where the sensor is remotely located from the host controller. The board does not require calibration, nor does it require any software programming - only the board GUI must be installed. Temperature and relative humidity data can be logged and exported in CSV format.
Streaming relative humidity and temperature measurements
Data logging
Full register access
USB plug and play
Detachable sensor section for prototyping remote operation