The AT91SAM9G15-EK is an evaluation kit that enables the evaluation and code development of applications running on a SAM9G15 device. The SAM9G15, based on the ARM926EJ-S processor, runs at 400MHz and integrates a rich set of peripherals to support embedded industrial applications that require advanced user interfaces and high speed communication. The SAM9G15 features a graphics LCD controller with 4 layer overlay and 2D acceleration (picture-in-picture, alpha blending, scaling, rotation, colour conversion) and a 10bit ADC that supports 4/5wire resistive touch screen panels. Multiple communication interfaces include a soft modem supporting exclusively the conexant SmartDAA line driver, HS USB host and device and FS USB host with dedicated on chip transceivers, two HS SDCard/SDIO/MMC interfaces, USARTs, SPIs, I2S and TWIs.
Equipped with 400MHz CPU, external memory, DDR2-SDRAM (1Gb), NAND flash (2 or 4Gb),Three USB ports
HS (EHCI) and FS (OHCI) host, multiplexed with HS USB device via micro AB connector
HS (EHCI) and FS (OHCI) host, via standard type A connector
FS only (OHCI) host, via standard type A connector
Two Ethernet 10/100 interfaces with on board MAC controllers and RJ45 sockets
Two high speed SD/MMC interfaces
One ZigBee extension port and 24bit RGB interface
One stereo CODEC interface with line-in and headphone jacks
One telephone/modem interface with RJ11 connector
5.0" TFT-LCD module with 800x480 resolution backlight with resistive touch panel
The board must not be subjected to high electrostatic potentials. In risky ESD environments a grounding strap or similar protective device should be worn when handling the board.
