The AT91RM9200-EK is an evaluation board for AT91RM9200 ARM9 based 32bit RISC microcontroller which enables real time code development and evaluation. The AT91RM9200 is a complete system on chip built around the ARM920T ARM Thumb processor. It incorporates a rich set of system and application peripherals and standard interfaces in order to provide a single chip solution for a wide range of compute intensive applications that require maximum functionality at minimum power consumption at lowest cost. The AT91RM9200 incorporates a high speed on chip SRAM workspace, and a low-latency external bus interface (EBI) for seamless connection to whatever configuration of off-chip memories and memory mapped peripherals is required by the application. The AT91RM9200 integrates a wide range of standard interfaces including USB 2.0 full speed host and device and Ethernet 10/100 base-T media access controller (MAC).
The board consists of an AT91RM9200 with 8Mbytes of parallel flash memory
Four banks of 2M x 32bit SDRAM
Data flash or SD/MMC memory expansion socket
Digital to analog converter (DAC) for a stereo audio signal
Four communication ports (USB host and device, Ethernet, serial and DBGU)
Graphic controller with output to a standard VGA monitor
JTAG/ICE, ETM and code test port interface
Expansion connector
On board prototype area
The board must not be subjected to high electrostatic potentials. A grounding strap or similar protective device should be worn when handling the board.
