下载
For further information contact your local STMicroelectronics sales office.
September 2012 Doc ID 018751 Rev 3 1/4
4
ST-LINK/V2
ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32
Data brief
Features
■ 5 V power supplied by a USB connector
■ USB 2.0 full speed compatible interface
■ USB standard A to mini B cable
■ SWIM specific features
– 1.65 V to 5.5 V application voltage
supported on SWIM interface
– SWIM low-speed and high-speed modes
supported
– SWIM programming speed rate:
9.7 Kbytes/s in low speed and
12.8 Kbytes/s in high speed
– SWIM cable for connection to the
application via an ERNI standard
vertical connector (ref: 284697 or 214017)
or horizontal connector (ref: 214012)
– SWIM cable for connection to the
application via a pin header or a 2.54 mm
pitch connector
■ JTAG/serial wire debugging (SWD) specific
features
– 1.65 V to 3.6 V application voltage
supported on the JTAG/SWD interface and
5 V tolerant inputs
– JTAG cable for connection to a standard
JTAG 20-pin pitch 2.54 mm connector
– JTAG supported
– SWD and serial wire viewer (SWV)
communication supported
■ Direct firmware update feature supported
(DFU)
■ Status LED which blinks during communication
with the PC
■ Operating temperature 0 to 50 °C
■ 2500 VRMS high isolation voltage
(ST-LINK/V2-ISOL only)
Table 1. Device summary
Part number Order Code Description
ST-LINK/V2
ST-LINK/V2
In-circuit debugger/programmer
ST-LINK/V2-ISOL
In-circuit debugger/programmer with digital isolation
ST-LINK/V2
ST-LINK/V2-ISOL
www.st.com
