下载
Maxim > Design Support > Technical Documents > Application Notes > Communications Circuits > APP 3464
Keywords: current source, software-programmable, voltage controlled, digital potentiometer
APPLICATION NOTE 3464
Precision Current Source is Software-
Programmable
Mar 14, 2005
Abstract: A shunt regulator provides a constant reference voltage across a digital potentiometer that, in
conjunction with an op amp and transistor, forms a software-programmable, voltage-controlled current
source.
With the addition of a few inexpensive miniature components, the hard-wired, voltage-controlled current
source of yesterday becomes a software-programmable voltage-controlled current source (Figure 1).
A digital potentiometer (U1) in conjunction with a precision op amp (U2) sets current through the pass
transistor (I
SET
), and a shunt regulator (U3) provides a constant reference voltage across the digital pot.
By operating in its linear region, the transistor controls load current in response to the applied gate voltage.
Each incremental step of the digital pot increases or decreases the voltage V
IN+
at the op amp's
noninverting input. Thus, the pot's wiper voltage (V
IN+
) varies with respect to the reference voltage, which
in turn remains stable with respect to the supply rail:
Many types of digital potentiometers are currently available, and the interface to these devices (besides
the hard-wired type) can be one, two, or three wires. U1, for example, has a 3-wire SPI interface, and
provides an end-to-end resistance of 50k½ with 256 incremental settings. Thus, each increment of the
digital pot changes V
IN+
by:
Op amp U2 regulates current through the pass transistor, and the digital pot sets current through the
R
SENSE
resistor. The voltage across R
SENSE
determines current through the pass transistor (I
SET
):
The circuit can provide any current level for which the external components (R
SENSE
and the pass
transistor) can handle the associated power dissipation (P = IV). Because the ratio setting of digital
potentiometers is very good (the typical ratiometric resistor tempco is 5ppm/°C), precision and stability for
the current source depends primarily on the precision and stability of U3 and R
SENSE
combined.
Page 1 of 2
