Datasheet
数据手册 > 运算,放大器 > ON Semiconductor > MC33072ADG 数据手册PDF > MC33072ADG 产品设计参考 第 1/12 页
MC33072ADG
¥ 8.78
百芯的价格

MC33072ADG 产品设计参考 - ON Semiconductor

更新时间: 2024-12-04 04:33:54 (UTC+8)

MC33072ADG 产品设计参考

页码:/12页
下载 PDF
重新加载
下载
EVAL-ADG5462FEBZ User Guide
UG-908
One Technology Way P. O. Box 9106 Norwood, MA 02062-9106, U.S.A. Tel: 781.329.4700 Fax: 781.461.3113 www.analog.com
Evaluating the ADG5462F User Defined Fault Protection and Detection, 10 Ω R
ON
,
Quad Channel Protector
PLEASE SEE THE LAST PAGE FOR AN IMPORTANT
WARNING AND LEGAL TERMS AND CONDITIONS.
Rev. 0 | Page 1 of 12
FEATURES
Supply voltages
Dual supply: ±5 V to ±22 V
Single supply: 8 V to 44 V
Protected against overvoltage on source pins
Signal voltages up to −55 V and +55 V
LEDs for visual overvoltage indication
Parallel interface compatible with 3 V logic
On-board low dropout (LDO) regulator for digital supply and
control, if required
EVALUATION KIT CONTENTS
EVAL-ADG5462FEBZ evaluation board
DOCUMENTS NEEDED
ADG5462F data sheet
EVAL-ADG5462FEBZ user guide
EQUIPMENT NEEDED
DC voltage source
±22 V for dual supply
44 V for single supply
Optional digital logic supply: 3 V to 5 V
Analog signal source
Method to measure voltage, such as a digital multimeter (DMM)
GENERAL DESCRIPTION
The E VA L -ADG5462FEBZ is the evaluation board for the
ADG5462F, which features an overvoltage protected quad
channel protector. The ADG5462F has overvoltage detection
and protection circuitry on the source pins and is protected
against signals up to −55 V and +55 V in both the powered and
unpowered states.
Figure 1 shows the E VA L -ADG5462FEBZ in a typical evaluation
setup. The ADG5462F is soldered to the center of the evaluation
board, and wire screw terminals are provided to connect to each
of the source and drain pins. Three screw terminals power the
device and a fourth terminal provides a user defined digital logic
supply voltage, if required. Alternatively, a LDO regulator is
provided for 5 V digital logic supply and to supply the LEDs,
which are mounted to provide visual indication of the fault status
of the switch.
Full specifications on the ADG5462F are available in the product
data sheet, which should be consulted in conjunction with this
user guide when using the evaluation board.
页面指南

MC33072ADG 数据手册 PDF

MC33072ADG 数据手册
ON Semiconductor
26 页, 298 KB
MC33072ADG 产品设计参考
ON Semiconductor
12 页, 399 KB
MC33072ADG 其它数据手册
ON Semiconductor
26 页, 298 KB
MC33072ADG 产品设计图
ON Semiconductor
3 页, 62 KB
MC33072ADG 应用笔记
ON Semiconductor
8 页, 113 KB

MC33072 数据手册 PDF

MC33072
数据手册
ON Semiconductor
Single Supply 3V to 44V Operational Amplifiers
MC33072
数据手册
Motorola
Amplifiers and Comparators
MC33072ADR2G
数据手册
ON Semiconductor
ON SEMICONDUCTOR MC33072ADR2G Operational Amplifier, Wide Bandwidth, 4.5MHz, 2 Amplifier, 13V/µs, 3V to 44V, SOIC, 8Pins
MC33072DR2G
数据手册
ON Semiconductor
ON SEMICONDUCTOR MC33072DR2G Operational Amplifier, Dual, 2 Amplifier, 4.5MHz, 13V/µs, 3V to 44V, SOIC, 8Pins
MC33072DG
数据手册
ON Semiconductor
ON SEMICONDUCTOR MC33072DG Operational Amplifier, Dual, 2 Amplifier, 4.5MHz, 13V/µs, 3V to 44V, SOIC, 8Pins
MC33072PG
数据手册
ON Semiconductor
ON SEMICONDUCTOR MC33072PG Operational Amplifier, Dual, 2 Amplifier, 4.5MHz, 13V/µs, 3V to 44V, DIP, 8Pins
MC33072APG
数据手册
ON Semiconductor
ON SEMICONDUCTOR MC33072APG Operational Amplifier, 2 Amplifier, 4.5MHz, 10V/µs, 3V to 44V, DIP, 8Pins New
MC33072ADG
数据手册
ON Semiconductor
ON SEMICONDUCTOR MC33072ADG Operational Amplifier, Dual, 2 Amplifier, 4.5MHz, 13V/µs, 3V to 44V, SOIC, 8Pins
MC33072DR2
数据手册
ON Semiconductor
OP Amp Dual GP ±22V/44V 8Pin SOIC N T/R
MC33072ADR2
数据手册
ON Semiconductor
Op Amp Dual GP ±22V/44V 8Pin SOIC N T/R
Datasheet 搜索
搜索
百芯智造数据库涵盖1亿多个数据手册,每天更新超过5,000个PDF文件。
相关文档: MC33072 数据手册
在线联系我们
黄经理 - 百芯智造销售经理在线,5 分钟前
您的邮箱 *
消息 *
发送